Compressor pressure switch manual

–Installation Manual and Information for VMAC OEM Compressor Hose Connections. T/T – Drive Disable Circuit (DDC) – Throttle and Park Brake Bypass Installation. – Ford (DDC) Drive Disable Circuit for column shift. – Pressure Switch Boot Retrofit Kit Air-Vantage Lincoln. Tighten strain relief nut. Place a fl athead screwdriver (not included) into raised notch and tap screwdriver with hammer (not included) until tight. Tighten strain relief screws to hold power cord securely. Replace the pressure switch cover (knob must be in the same position as when removed to sit correctly in place). Water Pump Pressure Switch, 40/60 PSI, DPST w/ Manual Switch Low Pressure Cut-Off FSG2J24M4 Water Pump Pressure Switch, 40/60 PSI, DPST w/ Manual Switch Off at PSI FHG12J52 Air Compressor Pressure Switch, SPDT, PSI, Off at PSI. SKU: FHG12J52 Square D. SKU: FHG12J Brand: Square D (2)-+ $ each .

–Installation Manual and Information for VMAC OEM Compressor Hose Connections. T/T – Drive Disable Circuit (DDC) – Throttle and Park Brake Bypass Installation. – Ford (DDC) Drive Disable Circuit for column shift. – Pressure Switch Boot Retrofit Kit Air-Vantage Lincoln. switch and disconnect any separate control lines, if used, before attempting to work or perform maintenance on the air compressor unit. "Tag Out" or "Lock Out" all power sources. motor - it may be hot enough 7. Do not attempt to remove any compressor parts without first relieving the entire system of pressure. 8. Do not attempt to service any. compressor. Moving the switch to the ON (1) position will provide automatic power to the pressure switch which will allow the motor to start when the air tank pressure is below the factory set cut-in pressure. When in the ON (1) position, the pressure switch stops the motor when the air tank pressure reaches the factory set cut-out pressure. For.

The Compressor Motor is controlled by the Manual Start Switch, the. Timer Circuit and the Pressure Switch. These are contained in the. Electrical Control. Use the big set screw to adjust the cut-in pressure. To increase, turn it clockwise. Close the drain valve. The compressor will run again until it reaches the. Turn off the compressor and remove the cover from the switch exposing the adjustment nuts. Be sure not to touch the electrical terminals, turning the circuit.